|
Post by csulaguy on Nov 17, 2020 11:19:23 GMT
LOL. That's pretty badass. Might as well leave your mark, since it is a rebuild after all.
|
|
|
Post by elec573 on Nov 26, 2020 1:54:52 GMT
Nice touch don’t forget the year . This could be a mini time capsule . Or it could wind up in a museum some time in the future. In the year 2525 if man is still alive …
|
|
|
Post by coldspaces on Nov 26, 2020 16:48:22 GMT
Travis is afraid labeling it this year will jinx it lol. And I love that song.
|
|
|
Post by coldspaces on Nov 26, 2020 16:49:55 GMT
Yesterday I found time to reassemble the pump and stator for this unit. I am very pleased to announce it runs!! youtu.be/FWtRc6xEdhE
|
|
|
Post by turbokinetic on Nov 27, 2020 3:30:42 GMT
Yesterday I found time to reassemble the pump and stator for this unit. I am very pleased to announce it runs!! youtu.be/FWtRc6xEdhEExcellent, and thanks for posting the video!
|
|
|
Post by coldspaces on Dec 3, 2020 0:57:00 GMT
|
|
|
Post by coldspaces on Dec 3, 2020 4:25:36 GMT
Well its all welded shut and under 40 psig nitrogen pressure since last night. Looks like it might be losing a little pressure, most likely at the rubber caps I have on the lines. Got to busy today to check it and see. Here is the video on the final assembly and welding. youtu.be/5pdJ7X8rxLA
|
|
|
Post by turbokinetic on Dec 3, 2020 15:29:12 GMT
Well its all welded shut and under 40 psig nitrogen pressure since last night. Looks like it might be losing a little pressure, most likely at the rubber caps I have on the lines. Got to busy today to check it and see. Here is the video on the final assembly and welding. youtu.be/5pdJ7X8rxLAWonderful to see it going back together! Your dedication and patience is endless with this project. It's great to see this, for sure.
|
|
|
Post by elec573 on Dec 17, 2020 0:53:16 GMT
Well its all welded shut and under 40 psig nitrogen pressure since last night. Looks like it might be losing a little pressure, most likely at the rubber caps I have on the lines. Got to busy today to check it and see. Here is the video on the final assembly and welding. youtu.be/5pdJ7X8rxLAWonderful to see it going back together! Your dedication and patience is endless with this project. It's great to see this, for sure. Patience is what you need and attention to detail. Both you seem to have in abundance from what I’ve seen . Was wondering what you were using for welding it back to gather? Wire size and heat setting? Was thinking you could use a small rotisserie like from a grill , to turn it continues while you weld it . To get a good continues weld . Looking forward to seeing it all back together and running!
|
|